This DIY hummingbird feeder can be made using some pieces of PVC pipe and an empty bottle. You can follow the instructions from this video to convert empty glass bottles to make a pretty hummingbird feeder DIY. Turn a chick brooder lamp into a warm place where hummingbirds can flock during winter. This DIY will help you to keep the hungry birds with one of the best DIY hummingbird feeder ideas. This wooden homemade hummingbird feeder idea is a simple one that can be given the shape of a birdhouse to feed hungry birds. Searching for DIY hummingbird feeder ideas? The empty bottle of wine can be put to good use by making a DIY bird feeder that will help attract hummingbirds to your home and garden. Hang the bottle from the knotted end of the twine upside down.Beautiful Hummingbirds In Georgia 2. You have to be careful because if you crimp it, it will drip.įill the bottle with sugar water or hummingbird food and carefully push the cork into the bottle. Adding Cork & Food:Ĭarefully push the bendy end of the straw into the hole in the cork. Just be sure you keep it even, so when it is hanging it is not lopsided. Then pull all four strings evenly about five inches from the bottle and tie them in a knot. When you get to the bottle base of the bottle, lay it on its side. Keep doing this, switching sides of the bottle so that it makes a netting down the bottle. Then turn it around and do the same thing on the other side. Now grab one string from each side and tie them so they join on a side where there is no knot. Then tie them in a knot on each side of the bottle just as the neck meets the rest of the bottle. Put the bottle in the center of those pieces with one string on each side. You should have a cute little flower.Ĭarefully pinch the end of the flower and insert it into the long end of the straw.īefore using the feeder for the first time, it is a good idea to run some water through the straw and cork just be sure all little pieces of debris are gone.Ĭut two pieces of twine that are both about 60 inches long. Now slightly pinch the end of the smaller piece and insert it into the flanged end of the larger piece. Next, cut another piece of the bright straw so it is about half the size of the last one. ![]() Then fold those cuts out so it starts to kinda look like a flower. Then using the scissors make cuts in the end about halfway down. Next, snip about an inch and a half pice of the bright colored straw. ![]() It is very important to only make the hole to the size of the straw. Hold the drill running in the cork pushing it in and out to make sure it is clear. After I drilled all the way through I backed it out then drilled again. Start by drilling a hole in the middle of the cork.
0 Comments
Leave a Reply. |
AuthorWrite something about yourself. No need to be fancy, just an overview. ArchivesCategories |